Our Address is: 1 Rossler drive, Girard Ohio. 44420

To properly ship your transmission. Start with a pallet longer and wider than the transmission it self, then place a 2x4 on each side of the transmission,  to prevent it from sliding around. Then bolt a 24"x24" peace of ply-wood threw the bottom two bell housing bolt holes. Then screw it to another 2x4 on the inside of the ply wood. (Its best to place the plywood against the bell housing  then place your long 2x4 on the inside of the plywood. Remove the plywood and screw it to the pallet Put the plywood against the bell housing mark the bottom two holes with a center punch. Remove the plywood and drill the two holes with a 1/2 drill bit). Then use a ratchet strap or metal strap around the middle of the transmission securing it to the pallet to keep it from flopping around during shipping.  Make sure that the pallet has plenty of room to get pallet mover or fork lift under. As seen in two pictures below

DANGER NEVER EVER SHIP YOU'RE TRANSMISSION IN A PLASTIC TOTE OR SEND UPS FEDEX GROUND